Does not turn on after power on:
1. Please confirm whether the power cable is connected properly.
2. Please confirm whether the power supply used meets the power supply requirements of the motherboard.
3. Try to reseat the memory module.
4. Try replacing the memory module.
5. Try to clear the motherboard COMS according to the motherboard manual.
6. Please confirm whether there are external devices and whether it is normal to remove the external devices.
BIOS Setup settings cannot be saved
Please confirm whether the COMS battery voltage is lower than 2.8V. Please replace the battery with a new one and save the device again.
Blue screen or crash when entering the system
1. Please confirm whether the memory module and external devices are loose.
2. Try to remove the newly installed hardware and uninstall the driver or software.
3. Try to replace the memory.
Slow entry into operating system
1. Try using third-party software to check whether the hard drive is damaged.
2. Please confirm whether there is too little remaining space in the partition where the system is located.
System automatically restarts
1. Please confirm whether the reset button of the industrial computer is accidentally triggered.
2. Please use anti-virus software to confirm whether the system is infected with viruses.
3. Please confirm whether the memory module and external devices are loose.
USB device cannot be detected
1. Please confirm whether the USB device requires separate power supply.
2. Please confirm whether there is poor contact in the USB interface.
3. Please confirm whether the controller is turned on in BIOS Setup.
